The internal cleaning of the crusher is very important
As a new type of crushing equipment, the Construction Waste Crusher has been purchased and used by more and more people, and has become the choice of large and medium-sized enterprises and even individual households. In the current majority of users are only concerned with production and use, paying less attention to the cleaning of the equipment, sometimes inevitable problems in the production process, so that the user is in a passive state, so that the crusher can not continue to invest produce.
First, before we prepare to use and start up, we must first check whether the components inside the fuselage are firmly installed, whether there is looseness, and there is no oil stain on the belt and the pulley. It should be wiped clean with a clean rag in time, do not leave stains. And dust. Whether there is any residue material in the feed port and the discharge port, it is necessary to timely process to ensure the discharge port and the feed port are clean and tidy. At the same time, it is necessary to see if there are any other debris in the crushing chamber of the equipment, and also clean it up in time. For the specially designed metal crusher, there is a lining plate placed in the crushing cavity. At the same time as the rotary cutter is selected, the metal material will grind some paint on the lining. We must also ensure that there is no impurity or paint house inside. Only in the early stage, we have done these cleaning work, so as to ensure that the equipment will not appear in the use of other materials should not appear in the use, so as not to affect your production and use, but also make the Quarry crusher life longer. For a long time, bring you more convenience.
When cleaning the crusher, the first thing to pay attention to is the safety problem. You must disconnect the power supply before you can clean it. Then open the inside of the crushing chamber, clear the remaining material, and then clean the residual material on the hammer. When cleaning, use a cleaning tool such as a brush or a towel to avoid injury. After cleaning the material, clean it with 75% ethanol and then close the crushing chamber. At this point, the interior has been cleaned, the rest is to clean the appearance of the crusher, the ground is also to be cleaned. After this is done, then boot up and see if there are any errors.